Lightweight 2"steel driveshaft lengths measured from center of u-joint to center of u-joint. Several lengths are available. Fits most IMCA style modifieds.
U-joints and yokes available separately so you can order the drive shaft combo YOU need.
The u-joint #48315 works for the front u-joint position on these drive shafts and with the front yokes shown here. Any of the three u-joints listed below will work on the back u-joint location based on rear axle requirementDrive Shaft Lenght:
Length is measured from the centerline to centerline of the u-joint.
Slip Yoke Lenght:
Longer slip yokes help compensate for extreme travel in rear suspension setups. They fit the common GM 3 and 4 speed transmission with 1 1/16 spline output shaft
